Silicone Tin RTV
General List R-1300 Series
These two-part, Tin RTV (Condensation Cure) Silicone rubbers are designed for their exceptional performance properties— high knotty tear, elongation, and tear strength. They are user-friendly and cure over most surfaces, and are used primarily for making flexible, high strength, production molds and parts. Use molds to cast polyester, urethane, epoxy, low melt metal (350F), thermoplastics (Polyvinyl), wax, soap, plaster, and any material where a release free casting is required.
Features:
1) Excellent Physical Properties with High Tear Resistance
2) Low Viscosity for Easy Mix and Pour
3) Highly Flexible for Severe Undercuts
4) Available Brush-On Catalyst *Use R-1300TH B
5) Cure Accelerator *Use Rapid Set
| R-1318-10 | R-1318 | R-1328 | R-1348A R-1332 B | R-1348A RN-1348 B | |
| Color: | Green | Green | Green | Grey | Orange |
| Mix Ratio: | 100A/10B | 100A/10B | 100A/10B | 100A/10B | 100A/ 5B |
| Mix Viscosity: | 25,000 | 28,000 | 30,000 | 40,000 | 40,000 |
| Specific Gravity: | 1.10 | 1.15 | 1.14 | 1.15 | 1.15 |
| Hardness Shore A: | 10 | 15 | 25 | 30 | 40 |
| Tensile Strength psi: | 390 | 400 | 520 | 550 | 550 |
| Elongation: | 610% | 550% | 310% | 340% | 400% |
| Tear Resistance: | 85 | 100 | 110 | 110 | 115 |
Mixing and Curing
Weigh appropriate amounts of Base (part A) and Catalyst (part B) and mix thoroughly until a uniform color is achieved. Most systems require 10% catalyst (by weight) and have a pot life of 45 minutes to 1 hour. Allow 16 to 24 hours before demolding. For fast cures use Rapid Set additive at 4 to 16 drops/lb (1 to 6 hour cures).
After the mold has been removed from the master, it should be left for 24 hours in order to develop its maximum mechanical strength. Please do not hesitate to call for further information.
The information and data contained herein are based on information we believe reliable. Each user of the material should thoroughly test any application and independently conclude satisfactory performance before commercializing. Suggestions of uses should not be taken as inducements to infringe on any particular patent.